DRESSTA Co. Ltd. TD-40C98/1E — 5.11. ENGINE

MAINTENANCE SECTION 5 Page 31 5.10. ELECTRICAL SYSTEM Check amount of charge of batteries: 100% of full charge ...............................................................................................1.26 – 1.28 g/cm 3 75% of full charge .................................................................................................1.23 – 1.25 g/cm 3 50% of full charge .................................................................................................1.20 – 1.22 g/cm 3 Fully discharged ....................................................................................................1.11 – 1.13 g/cm 3 5.11. ENGINE 5.11.1. CHECKING THE CRANKCASE OIL Fig. 5.16.

Oil Level Gauge WARNING! Park the machine on level ground, stop the engine, lower all mounted equipment to the ground, lock the transmission shift lever in neutral, apply the brake pedal lock, turn off the electrical system master switch. Stop the engine and check level. For an accurate reading wait for the oil to drain into the crankcase pan. Open hood side access door. Remove the oil level gauge and wipe it clean. Reinsert the gauge completely. Remove the gauge and check the oil level. If the level is at or below the ADD mark, add oil through the fast fill receiver to bring the level up to the FULL mark on the gauge.

Refer to “REFILL SPECIFICATIONS AND CAPACITIES CHART” for type and viscosity of oil specified. Reinstall the level gauge. NOTE: Never run the engine if the level of the oil is at or below the ADD mark on the oil level gauge. 1. Every 250 hours of operation check and clean crankcase breather hoses (3 pcs). For cleaning remove crankcase breather housing and clean with compressed air in reverse direction to that of normal operation. Damaged breather must not be used. 2. Check the engine for leaks. DRESSTA TD-40C