DRESSTA Co. Ltd. TD-40C98/1E — 5.11. ENGINE

MAINTENANCE SECTION 5 Page 33 5.11. ENGINE NOTE: Use only recommended filters available from Authorized Distributor of Construction Equipment. 1. When coolant reaches the temperature of app. 60°C, stop the engine and drain the crankcase oil. 2. Clean the filters and filter head. Remove spin-on filters. 3. Clean filter head in spin-on filter seal contact area. 4. Apply a little clean engine oil to the seal of new filter (2 pcs for replacement for QSK-19 Engine and 3 pcs for replacement for KT-19C Engine), fill the filter with engine oil and thread the filter on by hand per instructions specified on the filter. IMPORTANT: Thread the filters by hand.

Do not use any tools to install the filters because this can damage the filter. 5. Fill the crankcase with fresh oil. Refer to the “REFILL SPECIFICATION AND CAPACITIES CHART.” 5.11.2.2. Crankcase Fast Fill System For fast draining crankcase oil, remove protective cover from receiver and connect drain pump nozzle. For draining oil must be warm. For filling the system connect fill pump nozzle to the receiver and fill the crankcase with oil. Fig. 5.19. Oil Fill Tube DRESSTA TD-40C