MAINTENANCE SECTION 5 Page 35 5.11. ENGINE Inspection and Cleaning Make certain that ether is available under pressure. To do so, remove the ether container and check if a good spray is obtained. Test the ether injector as follows: 1. Disconnect the ether tube at the spray nozzle in the engine manifold. Remove the spray nozzle. 2. Reconnect the nozzle to the tube. Direct the nozzle away from the engine and actuate the ether injector. Dribbling or no spray indicates a blocked spray nozzle or tube. If necessary, clean or replace spray nozzle and/or tube. Fig. 5.21. Ether Fluid Container Changing the Fluid Container 1. Loosen the nuts securing the fluid container support saddle. 2.
Unscrew and discard the container from the ether starting valve in a suitable, closed refuse container. 3. Install the new container in the valve. 4. Secure the container in place by tightening the saddle nuts. Do not over tighten the nuts. 5.12. FUEL SYSTEM General Cleanliness of diesel fuel determines the service life of the fuel components. Water and contaminants, allowed to reach precision components, cause rapid wear and poor performance. Clean fuel and regular servicing of the fuel tank and fuel filtering components are necessary for long service life. Always clean the area around the fuel tank filler cap before refueling. WARNING!
Fire hazard – never mix gasoline and/or alcohol with diesel fuel. This practice creates an extreme fire hazard and under certain conditions an explosion, which could result in personal injury or death. DRESSTA TD-40C