MAINTENANCE SECTION 5 Page 37 5.12. FUEL SYSTEM 5.12.4. FUEL FILTERS 5.12.4.1. Fuel Filter Water Separator Drain Valve Spin-on fuel filters equipped with water separator are used in fuel system. Water and foreign materials separated from fuel, which settle to the bottom of the filter, are drained from the fuel thru drain valve located in lower part of the filter. Fig. 5.24. Fuel Filters (Water and Sediment Fuel Filter Drain Valve Shown by Arrow) Open the valve and drain water and sediment from the filter until clean diesel fuel appears. Close the valve. NOTE: Water contaminated with sediment and fuels as well as oil are detrimental to environment.
Drain water to suitable container and utilize in appropriate area. 5.12.4.2. Replacing the Fuel Filter Replace fuel filter when the engine is misfiring, loss of power is evident or after 250 hours. Keep the new filter in the original package until ready for installation. Before loosening the filter, clean the filter head to prevent dirt or foreign material from entering the system. 1. Close the fuel shutoff valve under the fuel tank. 2. Remove the fuel filters from the filter header using a filter removal wrench. 3. Thoroughly clean the filter header to prevent dirt or foreign material from entering the system. 4. Fill fuel filter with clean fuel. 5.
Apply a light coating of clean engine oil to the seal surface on the new filter. 6. Install the new filter, turning it until the seal just contacts the filter head and tighten the filter an additional 1/2 to 3/4 turn. NOTE: Thread the filters by hand. Do not use any tools to install the filters because this can damage the filter. DRESSTA TD-40C