SECTION 5 MAINTENANCE Page 38 5.12. FUEL SYSTEM NOTE: Use only recommended filters available from Authorized Distributor of Construction Equipment. 5.12.5. DRAINING FUEL TANK Fig. 5.26. Fuel Tank Drain Valve Periodically open the valve and drain water and sediment from the fuel tank until clean diesel fuel appears. Close the valve. 5.13. HYDRAULIC SYSTEM General WARNING! Always lower all mounted equipment to the ground before performing work on the hydraulic system. With all mounted equipment lowered to the ground and the engine off, cycle all hydraulic controls in all directions to relieve trapped pressure.
Slowly loosen the hydraulic reservoir filler cap to relieve trapped reservoir pressure. 5.13.1. CHECKING OIL LEVEL 1. Park the machine on level ground lower the blade and the ripper to the ground and stop the engine. 2. Check oil level at sight gauge on the side of the reservoir. Add oil if level is below the center line of the gauge. Refer to “OIL CHANGE”. NOTE: Before removing any components from the reservoir or servicing, wipe the top surface of the reservoir, using clean kerosene or a commercial cleaning solvent. TD-40C DRESSTA