DRESSTA Co. Ltd. TD-40C98/1E — 5.13. HYDRAULIC SYSTEM

MAINTENANCE SECTION 5 Page 39 5.13. HYDRAULIC SYSTEM Fig. 5.27. Hydraulic Reservoir Sight Gauge 5.13.2. CHANGING HYDRAULIC OIL 1. Start the engine and operate the blade to warm the oil for easy draining. 2. Park the machine on level ground, lower the blade and the ripper to the ground. 3. Stop the engine. Shift to neutral and apply the neutral lock lever. Apply and lock the parking brake. Turn the electrical system master switch to OFF and remove the key. Slowly loosen reservoir filler plug to relieve reservoir pressure. 4. Drain the reservoir into a suitable container by removing the filler plug and the drain plug (Fig. 5.28). 5.

Replace two return filters of hydraulic system and equipment hydraulic control circuit filter. Refer to “SERVICING THE RETURN FILTER”. Service the suction strainer as described under “SERVICING THE SUCTION STRAINER”. Service fuel tank filler strainer. Fig. 5.28. Hydraulic Reservoir Drain Plug DRESSTA TD-40C