DRESSTA Co. Ltd. TD-40C98/1E — 5.19. UNDERCARRIAGE

MAINTENANCE SECTION 5 Page 59 5.19. UNDERCARRIAGE 1. Remove the bolts and track adjuster cover. WARNING! Before adding lubricant for track adjustment, be sure the ball check and relief valves are properly torqued to 61 – 75 Nm. Fig. 5.52. Track Adjuster 1. Track Adjuster Cover 2. Relief Valve 3. Lubrication Fitting (Ball Check Valve) 2. To increase track tension, connect a lubricator nozzle to the lubrication fitting (3). Determine the amount of adjustment necessary, and add lubricant to obtain the proper track chain tension. It is advisable to move the machine forward and backward slightly to be sure the correct tension has been obtained. 3.

To reduce track tension, loosen the relief valve (2) 1/2 to 1 full turn to allow the pressurized lubricant to escape through the relief passage. If lubricant does not appear, loosen the check valve (located under the lubrication fitting) 1/2 to one full turn to allow the pressurized lubricant to escape from a second relief passage. 4. If lubricant still does not appear, use the following emergency method. Should the relief passages still be blocked, unscrew the ball check and/or relief valve an additional 1 1/2 to 2 turns (2 1/2 total turns). WARNING! Use extreme care when relieving pressure with the following emergency method.

If loosened excessively, the cylinder pressure can eject the ball check or relief valve. NEVER loosen these parts more than a total of 2 1/2 turns. 5. When the proper tension has been obtained, tighten the ball check and/or relief valve to 61 – 75 Nm. Install the cover and secure with removed hardware. NOTE: Never remove one link to bring a stretched track to within the range of proper track adjustment. A track that is worn badly enough to take up the length of one link, will be so far out of pitch that the increased wear on the sprocket will far more than offset the saving obtained by the removal of one link in the track chain. DRESSTA TD-40C