SECTION 5 MAINTENANCE Page 58 5.19. UNDERCARRIAGE 5.19.3. CHECKING THE TENSION Fig. 5.51. Checking Track Tension A - Track Sag for Normal Operations B - Track Sag for Mud and Snow Packing 1. Place a wooden block, ~300 mm in height, under the front most track shoe lug. Drive the machine forward until the track chain is tight along the ground and around the sprocket. Apply and lock the brake pedal, lock the transmission shift lever in the NEUTRAL position and stop the engine. 2. Stand on the track between the front idler and the first track idler in order to accumulate all the chain slack at this point. 3. Place a straightedge on the track so the ends rest over the front idler and track idler.
Measure the clearance between the bottom of the straightedge and the top of the shoe grouser with a ruler at the midway point between the idlers. If the distance is more than 64 mm or less than 38 mm, adjust the track tension. 4. For mud and snow packing conditions track should be adjusted so sag is 64 – 76 mm. 5.19.4. ADJUSTING TENSION The track chains are adjusted by hydraulic pressure. When lubricant is introduced into the front idler fork through the lubrication fitting, it acts upon the piston within the front idler fork forcing the front idler fork and front idler forward for track adjustment. WARNING!
To avoid possible injury, always stand to the side of the bleeder plug when making track adjustment. The pressure in the front idler fork is held by the bleeder plug and check valve. A loose or improper thread fit of either of these parts can allow them to be ejected by the pressure of the lubricant, causing possible injury. When increasing track tension, be sure the bleeder plug and check valve are properly torqued. When relieving track tension, never loosen the bleeder plug and check valve more than 2 – 2 1/2 turns. TD-40C DRESSTA