DRESSTA Co. Ltd. TD-40C98/1E — 5.19. UNDERCARRIAGE

MAINTENANCE SECTION 5 Page 57 5.18. TRANSMISSION SYSTEM 6. Reinstall the transmission scavenger hose. 7. Reinstall the transmission guard. 5.19. UNDERCARRIAGE Periodically make observation checks on your undercarriage components. Check tracks, track rollers, track idlers, front idlers etc. for abnormal wear. Make adjustments to these problems before damages to these components occur. Once the wear on these components drops below zero percentage the option to recondition will also be lost. Refer to TD-40C Service Manual for dimensions indicating percentage of allowable wear. If this Service Manual is not available contact Authorized Distributor of Construction Equipment.

Clean mud and debris should from the undercarriage so components can perform properly. Every 1000 hours of operation check torque of sprocket mounting bolts and tighten if necessary. WARNING! Special knowledge and equipment are required to service lubricated track systems and their components. Unless you are completely familiar with servicing lubricated track systems do not make any attempt to remove them. Disconnecting the master link could cause the chain to whip off the front idler causing serious personal injury. Improper track tension and loose track shoes will cause damage and premature wear to the track.

When new tracks or track shoes are installed, track tension and track shoe bolts should be checked after initial 10 hours of operation and adjusted if necessary. 5.19.1. TRACK SHOE BOLTS The bolts used for attaching the track shoes to the tracks are heat-treated alloy bolts and will stand a considerable tightening strain. Ordinary bolts must not be used. Nuts must be assembled so that washer face is not against track link. Radius side of nuts must be against track link. Coat bolt threads and area under the head with engine oil. Torque value is 2400 Nm. 5.19.1.

EFFECT OF TRACK ADJUSTMENT ON UNDERCARRIAGE WEAR Tracks adjusted too tightly increase operating loads on final drives and accelerate wear on undercarriage components, especially in packing conditions. A machine in forward operation with correctly adjusted tracks will experience track loads only along the ground from the front idler to where the bushings engage the sprocket. Lubricated track systems are to be adjusted to provide a sag in the track chain between to front top idler and the front idler. Correct tension reduces stress levels throughout the undercarriage system. DRESSTA TD-40C