MAINTENANCE SECTION 5 Page 61 5.19. UNDERCARRIAGE Measure clearances "A" and "B". If the total is 6.5 mm or more, adjust by removing shims (4) from between the spacer blocks (5) and inner wear plate (2). Remove enough shims to reduce the total clearance (A+B) to 0.8 mm. Keep the removed shims for future use. If removal of all the shims (4) will not provide a total clearance of less than 6.5 mm, replace the wear plates (1 and 2) worn guide plate (3), as required. Reinstall the shims and repeat the check. Lubricate track frame guides. 5.19.6. PIVOT SHAFT Fig.
5.55.Track Frame Oil Filler Plug Remove the plug (one at each side), check oil level and if the lubricant is low, fill to the level of the plug opening. Reinstall and tighten the plug. NOTE: Refer to the “REFILL SPECIFICATIONS AND CAPACITIES” chart for grade of lubricant specified. 5.19.7. EQUALIZER BAR Fig. 5.56. Equalizer Bar Pivot Pin Lubrication Fitting DRESSTA TD-40C