DRESSTA Co. Ltd. TD-40C98/1E — 6.9. STANDARD METRIC FASTENERS

SECTION 6 SPECIFICATIONS Page 22 SPECIAL TORQUES Sprocket rock deflector mounting bolt ............................................................................... 850 [Nm] Front idler tapered pin retainer plug................................................................................... 270 [Nm] Track shoe bolt..........................................................................................................2400 (ref) [Nm] Track chain split link bolt ...........................................................................................2400 (ref) [Nm] Audio alarm mounting nut (on instrument panel) ....................................................

finger tight [Nm] Trunnion assembly bolt .................................................................................................. 1500 [Nm] Lift cylinder yoke bushing block bolt ............................................................................... 1500 [Nm] Cutting edge and end bit nuts.......................................................................................... 1500 [Nm] Trunnion bearing cap bolt ............................................................................................... 1500 [Nm] Track frame guide plate mounting bolt ............................................................................

1500 [Nm] Guide plate spacer bolt .................................................................................................. 1500 [Nm] Final drive planet carrier mounting bolt ............................................................................ 1500 [Nm] Final drive cover mounting bolt (to frame) ........................................................................ 1500 [Nm] Final drive wear guard mounting bolt ............................................................................... 1500 [Nm] Pivot shaft dipstick ...............................................................................................................

24 [Nm] Ripper mounting frame bolt ............................................................................................ 2800 [Nm] Ripper mounting frame bolts ........................................................................................... 3600 [Nm] Pivot shaft lock pin retainer plug ....................................................................................... 280 [Nm] 6.9. STANDARD METRIC FASTENERS This chart provides tightening torque for general-purpose applications using original equipment standard hardware.

Original equipment standard hardware is defined as coarse thread metric class 10.9 bolts and class 10.0 nuts and thru hardened flat washers (Rockwell "C" 38-45), all phosphate coated and assembled without supplemental lubrication (as received) condition. The torques shown below apply to phosphate coated bolts designed for 60% yield strength. The torques shown below also apply to phosphate coated bolts used with phosphate coated prevailing torque nuts, phosphate coated bolts used with copper plated weld nuts. NOMINAL THREAD DIAMETER [mm] STANDARD TORQUE ± 10% [Nm] 6 7 8 10 12 14 16 18 20 22 24 27 30 33 36 10 16 23 46 80 125 200 275 385 530 670 980 1330 1790 2325 TD-40C DRESSTA