SPECIFICATIONS SECTION 6 Page 23 6.10. TORQUE VALUES FOR STANDARD ENGLISH FASTENERS This chart provides tightening torque for general purpose applications using original equipment standard hardware as listed in the Parts Catalog for the machine involved. DO NOT SUBSTITUTE. Original equipment standard hardware is defined as Type 8, coarse thread bolts and nuts and thru hardened flat washers (Rockwell "C" 38-45), all phosphate coated and assembled without supplemental lubrication (as received) condition. Phosphate coated bolts used in tapped holes in steel or gray iron. 2. Phosphate coated bolts used with phosphate coated prevailing torque nuts (nuts with distorted threads or plastic inserts).
Phosphate coated bolts used with copper plated weld nuts. Markings on bolt heads or nuts indicate material grade ONLY and are NOT to be used to determine required torque. NOMINAL THREAD DIAMETER [in] STANDARD TORQUE ± 10% [Nm] 1/4 5/16 3/88 7/16 1/2 9/16 5/8 ѕ 7/8 1 1–1/8 1–1/4 1–3/8 1–1/2 1–3/4 2 10 21 38 60 92 130 180 325 520 780 1110 1565 2050 2720 3380 5080 6.11. TORQUE VALUES FOR SPLIT FLANGE CONNECTIONS The following chart provides the tightening torques for split flange connections used in hydraulic systems. Split flanges and fitting shoulders should fit squarely. Install all bolts, finger tight and then torque evenly.
Over torquing bolts will damage the flanges and/or bolts, which may cause leakage. Bolt size [in] Flange size [in]* Torque Value [Nm] 1/2 3/4 1 1–1/4 1–1/2 2 2–1/2 3 3–1/2 20–24 30–37 37–47 47–61 62–79 75–88 107–123 187–203 159–180 * – Inside diameter of hydraulic tube or hose fitting. 5/16 3/8 3/8 7/16 1/2 1/2 1/2 5/8 5/8 DRESSTA TD-40C