DRESSTA Co. Ltd. TD-40C98/1E — 6.14. TORQUE VALUES FOR AIR CONDITIONING TUBES AND FITTINGS

SECTION 6 SPECIFICATIONS Page 24 6.12. TORQUE VALUES FOR HYDRAULIC TUBES AND FITTINGS Size Tubing o.d. in inches Thread size in inches Torque values for 37 [°] flared fittings Torque values for O-ring boss plugs, locknuts and 37 [°] flared fittings 4 5 6 8 10 12 14 8–14 14–20 20–27 34–42 47–54 81–95 95–109 16 20 24 32 1/4 5/16 3/8 1/2 5/8 3/4 7/8 7/16–20 1/2 –20 9/16–18 3/4 –16 7/8–14 1-1/16–12 1-3/16–12 12–16 16–20 29–33 47–54 72–79 104–111 122–138 1 1–1/4 1–1/2 2 1-5/16–12 1-5/8–12 1-7/8–12 2-1/2–12 149–163 190–204 217–237 305–325 108–122 129–156 163–190 339–407 Above torque figures are recommended for plain, cadmium or zinc plated fittings, dry or wet installations.

These torques are not recommended for tube with wall thickness of 0.889 [mm] or less 6.13. TORQUE VALUES FOR HOSE CLAMPS The following chart provides the tightening torques for hose clamps used in all rubber applications (radiator, air cleaner, operating lever boots, hydraulic system, etc.). TORQUE ± 0.6 [Nm] CLAMP TYPE AND SIZE Radiator, Air Cleaner, Boots, etc [Nm] Hydraulic System [Nm] "T" Bolt (any diameter) 6.2 –7.3 Worm Drive – 1-3/4 [in]. Open Diameter & Under 2.2 – 3.3 4.5 – 5.6 Worm Drive – Over 1-3/4 [in]. Open Diameter 4.5 – 5.6 Worm Drive – Al1 "Ultra-tite" 10.7 – 11.8 4.5 – 5.6 6.14.

TORQUE VALUES FOR AIR CONDITIONING TUBES AND FITTINGS SWAGED 45 [°] CONNECTIONS TD-40C DRESSTA SIZE THREAD SIZE [in] TORQUE VALUES FOR MATERIALS [Nm] STEEL-STEEL BRONZE -STEEL COPPER-STEEL ALUMINUM-STEEL 1/4 3/8 1/2 5/8 3/4 7/16–20 5/8–18 3/4–16 7/8–14 1-1/16–12 1-1/16–14 16 – 23 27 – 33 47 – 54 61 – 68 72 – 80 72 – 80 15 – 20 23 – 38 38 – 46 45 – 53 49 – 57 49 – 57 15 – 20 23 – 38 38 – 46 45 – 53 49 – 57 49 – 57 12 – 18 20 – 25 28 – 36 34 – 42 45 – 53 45 – 53