SAFETY PRECAUTIONS SECTION 2 Page 7 OPERATION Never mix gasoline, gasohol and/or alcohol with diesel fuel. This practice creates an extreme fire hazard and under certain conditions an explosion, which could result in personal injury or death. Do not smoke when refueling or servicing the machine. A fire could result. Never place gasoline or diesel fuel in open pan. Never remove the fuel tank filler caps or refill the fuel tanks while the engine is running or hot or when the machine is indoors. Fumes are dangerous, a spark or flame could result in a fire or explosion.
On machines equipped with a suction fan or a reversible fan in the suction position, periodically check the engine exhaust system for leaks. Exhaust gases are dangerous to the operator. Do not operate the machine in a condition of extreme fatigue or illness. Be sure that the rear screen is securely fastened to the ROPS structure. Be sure chains or cables and their anchor points are strong enough to handle the expected load. Inspect carefully chains and cables for flaws before using them. Always wear gloves when handling cables and chains. Avoid looping or knotting a cable or chain.
Do not pull with a kinked chain or cable as excessively high stress in bent area may cause chain or cable failure. Cables or chains for towing or winching should be fastened to attachment points designed to this purpose only. Be sure the attachment pins are securely inserted immediately before pulling with the chain or cable. Stand clear of chains or cables under load. Keep engine exhaust system and exhaust manifold clear of combustible material for your personal protection. Know the locations of underground cables, water mains, gas lines, etc. A ruptured gas line or cut electrical cable could result in personal injury or death.
When leaving the machine unattended for any length of time, make sure the transmission shift lever is positioned and locked in neutral (N), the blade is completely lowered, the engine is stopped, the parking brake is applied, and the electrical master switch is in the “off” position. If the machine is equipped with a cab make sure that the cab is locked. Before operating the machine read and know the Operator’s Manual and all Safety Product Graphic. The roll-over protective structure (ROPS) provides the operator’s protection in the event of machine rollover or upset. This structure is designed to bend during rollover to protect the operator from sudden impact loads.
When operating the machine, look in the intended direction of travel and the immediate machine operational area to be sure personnel or allied equipment does not interfere with the machine work pattern. Never try to get on or off the machine while it is moving. A serious injury or death could result. DRESSTA TD-40C