SECTION 2 SAFETY PRECAUTIONS Page 8 OPERATION Never shift the transmission into neutral (N) when traveling downhill. The machine may go out of control and a rollover could result or the transmission, torque converter or engine could be damaged when the transmission is again placed in gear. Always put the transmission in low range position before starting downhill. Use the decelerator and brake pedal to slow the machine. Avoid side hill travel whenever possible. Drive straight up and down the slope. If the machine starts slipping sideways on a grade, turn downhill immediately. If possible avoid crossing obstacles such as ridges, rocks or logs.
If you can't avoid them, reduce speed and ease over the obstacle at an angle. A machine's weight and the vibration it creates can cause the edge of a high wall to collapse. Keep your machine away from the edges of banks and excavations. If it is not possible to avoid turn the machine front towards the bank edge or excavation. Travel slowly in congested areas or on rough ground, slopes or near drop-offs or on snow, ice or slippery surfaces. Maintain a safe distance between your machine and other vehicles according to the condition of the road and load. Never hold the hydraulic controls in their extreme position after the equipment has reached its maximum travel.
This could cause overheating of the hydraulic system. Do not adjust the seat position while the machine is in motion. A loss of control may result. Completely stop the machine, apply and lock the parking brake and then adjust the seat. Never use the blade as a brake except in an emergency. Carry the blade low for maximum stability and visibility. Where noise exposure exceeds levels defined by proper health and safety authorities and applicable standards wear authorized ear protective equipment. 2.4. MAINTENANCE Servicemen and their helpers only are allowed to remain at operator’ s post while maintaining or repairing the machine.
Authorized personnel only is allowed to control, maintain or repair a machine. Do not hurry. Haste could result in accident. Load things into the machine form the ground level before mounting the machine. Loosen the radiator cap slowly to relieve all pressure in the system and use caution when removing the caps. TD-40C DRESSTA