OPERATING SECTION 4 Page 19 STARTING THE ENGINE NOTE: Before operating the machine perform each of the 10 hour maintenance requirements referred to in Section 5.2. SCHEDULED MAINTENANCE. This engine cannot be started by towing, pushing or coasting the machine. WARNING! Before entering the operator s compartment, walk completely around the machine and clear the area of personnel and obstructions. WARNING! Read all product graphics before starting, operating, maintaining, or repairing the machine. WARNING! Before starting the engine or when the machine is standing with the engine running, lock the transmission shift lever in neutral, apply brake lock and lower all raised equipment: WARNING!
Understand all control functions before starting the engine. WARNING! Never start the engine indoors unless proper exhaust ventilation is provided to remove deadly exhaust gases. Once the engine is running, move the machine outdoors as soon as possible. Exhaust gases are hazardous and can cause unconsciousness and death. WARNING! Be sure all personnel are clear of the machine before starting the engine. Sound the horn. WARNING! Make sure the operator’s seat is adjusted properly and fasten the safety seat belt. 4.7.1. NORMAL START (temperature above 0°C) 1. Apply and lock the brake and decelerator pedal. 2. Place transmission shift levers in neutral. 3.
Place the neutral lock lever in vertical “ON” position. 4. Move the engine speed control lever to idle speed position (Fig. 4.16). 5. Turn on electrical system master switch (“ON”. 6. QSK-19 engine only. Turn the starting switch key from the OFF position to the RUN position (Fig. 3B). With the key in this position warning lights 5.1, 5.2 and 5.3 on the instrument panel will be on (Fig. 3A). After two seconds the warning light 5.2 will turn off followed by the light 5.1 and 5.3. This means that the engine self-detection feature disclosed no ECM failure.
If the ECM detects engine system failure (sensor damage, low oil pressure, low coolant level, etc.) it will be stored in ECM memory as an active failure. Turn the starting switch key into the OFF position, the diagnostics switch (2B, Fig.2) into its upper position and then turn the key into the RUN position to read active failure codes. Turn the 2A selector switch (Fig.2) into its upper and lower position to display the failure code. DRESSTA TD-40C