SECTION 4 OPERATING Page 20 STARTING THE ENGINE Failure code display (example): 115 (Fig. 15A) RED LIGHT YELLOW LIGHT YELLOW LIGHT YELLOW LIGHT RED LIGHT P P P P 1 FLASH 1 FLASH 1 FLASH 5 FLASHES 1 FLASH Fig. 15A. Failure code display (example) P.- one second interval Failure code 115 – engine rpm sensor damage For failure code – refer to QSK-19 ENGINE MANUAL Contact an Authorized Construction Equipment Distributor in case you find out any active engine failures. Fig. 4.16. Engine Speed and Shut Down Control Lever 6. Sound the horn to clear all personnel from the immediate area. 7. Crank the engine.
- press the start switch button (KTA-19C engine) - turn the starting switch key to the right to the START position (QSK-19 engine) 8. Check oil pressure. Stop the engine immediately if gauge fails to show correct pressure after 15 seconds. Allow the engine to idle for 3 to 5 minutes (app.1000 RPM.) before increasing the engine speed and placing under load. 9. Check indications of all instruments to ensure that machine is operating correctly. Refer to INSTRUMENT PANEL. IMPORTANT: It is not recommended to run the engine at low idle over 10 minutes due to possibility of accelerated wear of engine components. TD-40C DRESSTA