SECTION 5 MAINTENANCE Page 4 5.2. SCHEDULED MAINTENANCE GUIDE Every 10 Hours of Operation (Every Day) 1. Clean windows, lights and instrument panel. 2. Check engine oil level. Refer to 5.11.1. 3. Check radiator coolant level. Refer to 5.8.5 4. Check hydraulic system oil level. Refer to 5.13.1. 5. Check and clean precleaner screen, if necessary. Refer to 5.6.4.1. 6. Check level in window washer reservoir. Refer to 5.21 7. Carry out ground level inspection. Refer to 5.2.1. 8. Drain water from fuel filters prior to starting the work. Refer to 5.12.7. 9. Visually check the condition of drive belts. Refer to 5.7. and fan Refer to 5.9. 10. Check instruments and warning lights for operation.
Refer to 4.3. 11. Refill fuel tank at the end of each day’s operation. Refer to 5.12.1. 12*. Check torque: track shoe bolts. Refer to 5.19.1. blade cutting edge and end bit bolts. Refer to 5.15. trunnion cap bolts and trunnion mounting bolts. Refer to 5.15. * – after initial 10 hours of operation only. Every 50 Hours of Operation 1. Check oil level in rear mainframe. Refer to 5.18.1. 2. Clean radiator core (for QSK – 19 Engine clean also fuel cooler). Refer to 5.8.4.2. 3. Check and adjust track tension, if necessary. Refer to 5.19.3. and 5.19.4. 4. Check air intake system for leaks (hoses and clamps). Refer to 5.6.4.2. 5. Lubricate lift cylinder bearings. Refer to 5.14. 6.
Lubricate ripper cylinder bearings. Refer to 5.14. 7*. Replace hydraulic system return filters. Refer to 5.13.3. 8*. Replace transmission system pressure filters. Refer to 5.18.3. 9*. Clean transmission system suction strainer. Refer to 5.18.4. 10*. Replace equipment pilot filter. Refer to 5.13.3. * – after initial 50 hours of operation only. Every 250 Hours of Operation 1. Change engine crankcase oil. Refer to 5.11.2. 2. Change engine crankcase oil filters (2 filters for QSK – 19 and 3 filters for KT – 19C). Refer to 5.11.2. 3. Replace fuel filters (2 filters) (replace fuel filters earlier when drop in engine power is noticed). Refer to 5.12.4.2. 4.
Check coolant for DCA concentration and replace coolant filter. Refer to 5.8.3. 5. Check engine crankcase breather hoses. Refer to 5.11.1. 6. Check alternator belt and air compressor (if equipped) belt tension. Refer to 5.7.2. 7. Reverse fan blade (if equipped). Refer to 5.9. 8. Check final drive oil level. Refer to 5.17.1. 9. Lubricate upper struts and joints. Refer to 5.14. 10. Lubricate lower struts and joints. Refer to 5.14. 11. Lubricate gimbal crosstube. Refer to 5.14. 12. Lubricate fan idler arm (only QSK-19 if equipped). Refer to 5.9. TD-40C DRESSTA