DRESSTA Co. Ltd. TD-40C98/1E — 5.2. SCHEDULED MAINTENANCE

MAINTENANCE SECTION 5 Page 5 5.2. SCHEDULED MAINTENANCE GUIDE Every 500 Hours of Operation 1. Check oil level in pivot shaft housing. Refer to 5.19.6. 2. Lubricate equalizer bar pin. Refer to 5.19.7. Every 1000 Hours of Operation 1. Change oil level in rear mainframe. Refer to 5.18.2. 2. Clean transmission system suction strainer. Refer to 5.18.4. 3. Clean transmission scavenger suction strainer. Refer to 5.18.6. 4. Replace transmission system pressure filters. Refer to 5.18.3. 5. Replace rear mainframe breather. Refer to 5.18.5. 6. Change final drive oil. Refer to 5.17.2. 7. Check sprocket bolt torque’s. Refer to 5.19. 8. Replace hydraulic system return filters. Refer to 5.13.5. 9.

Clean hydraulic reservoir breather. Refer to 5.13.5. 10. Lubricate gimbal crosstube. Refer to 5.14. Periodic (at least once a year or as required) 1. Clean air cleaner elements or replace if necessary. Refer to 5.6. 2. Clean fuel tank filler strainer. Refer to 5.12.2. 3. Clean cab air filters. Refer to 5.21. 4. Drain water and sediment from fuel tank sediment bowl. Refer to 5.12.5. 5. Lubricate hand and foot linkage, check for operation and adjust if necessary. Refer to 5.20. 6. Lubricate equipment pilot valve plunger – to – plate surfaces. Refer to 5.20. 7. Check engine RPM with depressed decelerator. Refer to 5.20. 8. Check operation of brake lock. Refer to 5.20. 9.

Check undercarriage components for wear. Refer to 5.19. 10. Check track frames guide clearance and adjust if necessary, lubricate track frame guides. Refer to 5.19.5. 11. Check clearance in blade socket and diagonal struts. Refer to 5.15.1.2 ч 5.15.1.3. 12. Check the condition and amount of charge of batteries. Refer to 5.10.2. 13. Check the condition of electrical wires and connections. Refer to 5.10. 14. Check the condition of safety belt. Refer to 5.16. 15. Check torque: cab and ROPS mounting bolts. Refer to 5.21. track shoe mounting bolts. Refer to 5.19.1. blade cutting edge and end bit bolts. Refer to 5.15. trunnion cap bolts and trunnion mounting bolts. Refer to 5.15.2. 16.

Check cutting edges and end bits for wear. Refer to 5.15.3. 17. Check ripper points for wear. Refer to 5.15.3. 18. Check front wheel guide clearance. Refer to 5.19.8. Every 1500 Hours of Operation or every year (Per Engine Operator’s Manual) 1. Steam cleans the engine. 2*. Check and adjust valve and injectors. 3. Lubricate fan hub (for QSK – 19 engine only). 4. Check bypass oil filter and cooling system hoses and replace if necessary. 5. Check cold start aids (seasonal). DRESSTA TD-40C