DRESSTA Co. Ltd. TD-40C98/1E — 5.6. AIR CLEANING SYSTEM

MAINTENANCE SECTION 5 Page 17 5.6. AIR CLEANING SYSTEM IMPORTANT: Do not use compressed air to speed the drying of the element; the air pressure will rupture the wet element. 4. Lay the element on its side and allow it to air-dry before reinstalling. Overnight drying is usually sufficient. When drying the element, protect it from dirt and/or freezing NOTE: If no spare element is available, the wet element, after excess water has been shaken out, may be installed in the air cleaner and the engine operated at idle for 10 minutes before operating the tractor. 5. Inspect for damage. Refer to “INSPECTION.” Inspection 1.

Inspect the filter element for leaks or damage by placing a bright light inside the element. Inspection of the element on the outside will disclose any holes where concentrated light shines through. The slightest rupture requires replacement of the filter element. 2. Inspect the contact surfaces of the air cleaner body. If faulty or damaged surfaces are noted, correct these conditions immediately. Installation (Fig. 5.2) 1. Insert the open end of the primary element (3) into the air cleaner body (1) and secure with the washer (4) and wing nut (5). Installs cover (8) with gasket (9) onto the air cleaner body. Secure the cover to the body with locking clamps making sure cover is not cocked. 2.

Inspect and tighten all air cleaner connections before resuming operation. Start the engine. If the air cleaner, filter warning light indicates air restriction, replace primary or primary and safety filter elements. 5.6.3. SAFETY FILTER ELEMENT Service Replace the safety element with every third change of the primary element or when plugged, as shown by the filter warning light. Removal (Fig. 5.2.) 1. Remove primary element. Refer to 5.6.2. 2. Remove cotter key (7), nut (6) and washer (4) and pull safety element from body. Clean inside of body (1) with a damp cloth. Check the condition of gasket on the end of the safety element. If the gasket is damaged or missing, replace the gasket.

Installation (Fig. 5.2.) 1. Install new safety element (2) into the body and secure with nut (6) and washer (4). Secure bolt with cotter key (7). 2. Install primary filter element. Refer to 5.6.2. DRESSTA TD-40C