DRESSTA Co. Ltd. TD-40C98/1E — 5.7. BELTS

SECTION 5 MAINTENANCE Page 20 5.7. BELTS Replace badly worn, greasy or cracked belts immediately. These conditions prevent proper belt function. Visually inspect the drive belts for intersecting cracks. Transverse (across the belt width) cracks are acceptable. Longitudinal (direction of belt length) cracks that intersect with transverse cracks are not acceptable. Replace the belt if it is frayed or has pieces of material missing. 5.7.1. CHECKING TENSION AND ADJUSTMENT Checking tension The engine is equipped with an automatic belt tensioner that maintains correct tension on the drive belt. To check belt tension a Borroughs type gauge must be used. Adjustment Fig. 5.5.

Belt Tension Adjustment a – Fan Belt Tension Adjustment (only for QSK-19C Engine) b – Alternator Belt Tension Adjustment c – Air Conditioner Compressor Belt Tension Adjustment Belt tension adjustment: 1. Alternator belt – tighten or loosen nuts and adjusting bolt “b” until tension value specified in chart is obtained. 2. Air conditioner compressor belt- tighten or loosen nuts and adjusting bolt “c” until tension value specified in chart is obtained. 3. Fan belt (chart enclosed) – loosen locknut and relive belt tension. Move fan idler until it contacts with the belt. Turn locknut by hand until snug. Turn the locknut by full 9 turns using wrench. Then torque the locknut to 81 Nm.

TD-40C DRESSTA