Komatsu — Hoist Control

OM3013 02/99 Operation - Section 3 Operating Instructions Page 3-21 Determining "Fault" Codes 1. To determine an active "fault," turn the key- switch to the "OFF" position and wait until the engine completely stops. Differential Lock Pedal (Optional) If truck is equipped, this pedal (11, Figure 3-1) is used to actu- ate the differential lock control. 2. Turn keyswitch to "ON" position (engine NOT running) and hold the Fault Check switch (11) in the "ON" position. When the pedal is depressed, the differential lock is actuated, and when it is released, the dif- ferential lock is canceled. Refer to 330M Shop Manual for further details.

(12) Hoist Control The hoist control (12, Figure 3-1) is a four position, hand operated control lever located to the left of the operator seat. The hoist control lever and hoist con- trol valve are connected by a mechanical push-pull control cable. 3. If there is an active fault. a. The amber/yellow Engine Maintenance light (8) will flash once. b. There will be a 1-2 second pause, and then the red Engine Shutdown light (7) will flash out the three digit diagnostic code. To raise the dump body: (refer also to "Operating Instructions, DUMPING" ) Each digit is indicated with up to nine light flashes for each digit. There is a short pause between each digit of the fault code. 1.

Move Shift Lever (1) to the “N” position, and apply Parking Brake Valve Lever (6) to LOCKED posi- tion. c. After all three digits are flashed, the yellow lamp will flash once, and then the red lamp will repeat the same fault code sequence as before. Move dump lever to the "RAISE" posi- tion and release dump lever: it will remain in this position until moved to HOLD - either manually or by the body-up limit linkage. 4. The system will continue to flash the same fault code until the Fault Scroll Switch (12) is acti- vated again. 2. Raise engine RPM to accel- erate hoist speed.

When body is near the maxi- mum angle, reduce engine RPM (reduce foot pressure on the accelerator pedal) to reduce shock load to the hydraulic system and hoist cylinders. EXITING THE DIAGNOSTICS MODE Starting the engine, or turning the key- switch to the OFF position, will EXIT the diagnostics fault flash mode. 3. When the dump body rises to the set position (adjusted position of body positioner) dump lever returns to the hold posi- tion. If desired to raise the body further, move dump lever to raise position and dump body will rise. If dump lever is released, lever will return to hold position. Dump body will stop in that position.

If active fault codes have been determined as described previously, refer to the appropriate Komatsu engine manual.