OM4010 05/07 Maintenance - Section 4 Lubrication and Service Page 4-3 10 HOUR (DAILY) INSPECTION Prior to each operating shift, a walk around inspec- tion should be performed to check the truck’s general condition. Look for evidence of leaks, check all lights and mirrors for clean and unbroken lenses, check operator's cab for clean and unbroken glass, check frame, sheet metal and body for cracks. Notify the proper maintenance authority if any discrepancies are found. Check the following: Truck Serial Number ________________________ Site Unit Number ____________________________ Date:
__________ Hour Meter _________________ Name of Service Person ______________________ FLUID LEVELS & OTHER CHECKS - With Engine Stopped For the following checks, park the truck on a level surface, lower the dump body, and turn off the engine. 1. Radiator - Check coolant level (2). Coolant level should be between FULL and LOW. If cool- ant is low, fill through cap (1) to FULL level with proper mixture as shown in Cooling System Recommendation Chart. CAUTION - Allow engine sufficient time to cool before removing the fill cap or draining the radia- tor. Serious burns may occur if personnel comes in contact with hot coolant. * - Ensure that there are no contaminants in the cooling system.
* - Check for possible leaks if a significant volume of coolant has been added. Tighten cap securely. 2. Batteries - Check electrolyte level and add dis- tilled water if necessary. Inspect battery box cover for looseness or damage. 3. Front Brake Oil Tank - Check oil level (2). Add oil if necessary. Remove cap (1). Use SAE 10W, Engine Oil ONLY. After adding oil, tighten cap securely. 4. Momentarily pull chains (1) on the moisture drain valves to drain the moisture from the tanks. Check the brake chambers for leaks, damage, etc. COMMENTS CHECKED INITIALS