Komatsu — 10 HOUR (DAILY) INSPECTION

OM4010 05/07 Maintenance - Section 4 Lubrication and Service Page 4-7 10 HOUR (DAILY) INSPECTION (continued) OPERATIONAL CHECKS - Engine Running For these checks, park the truck on a level surface, lower the dump body, and operate the engine at approximately 1000 RPM, until air pressure, coolant temperature, engine oil temperature, and transmis- sion oil temperature gauges all indicate a Normal (green) Range. NOTE: Apply the parking brake and place the transmission control in the NEUTRAL (N) position. While the engine is at low idle, perform the following checks: The engine will be running during the following procedures.

Keep away from all moving parts, such as fans, belts, pulleys, drive shafts, etc. 1. Inspect engine and turbochargers for leaks, vibrations, or abnormal noises. 2. Check the transmission oil level at lower marks (2) on transmission oil pan decal. a. Use the upper marks (1) when engine is cold or engine has been stopped for more than 8 hours. b. If oil level is below the L mark, add oil through filler (1) as required. Refer to Lube Key F. c. Verify there are no leaks or any other abnormal conditions with the transmission or the drive shafts. COMMENTS CHECKED INITIALS