Maintenance - Section 4 OM4010 05/07 Page 4-8 Lubrication and Service 250 HOUR SERVICE INITIAL 250 HOUR SERVICE Truck Serial Number ________________________ Perform the following maintenance after running the machine for the first 250 hours . Site Unit Number ____________________________ Replace elements for the steering, hoist oil tank, and rear brake cooling oil tank. Date: __________ Hour Meter _________________ Name of Service Person ______________________ Change transmission case oil. Change steering and hoist tank oil. Change rear brake cooling tank oil. Change differential case oil. Change final drive case oil. Replace fuel filter cartridges. Replace transmission oil filter elements.
Thereafter, these services are to be accomplished at the 500/1000/2000 hour interval as scheduled. Refer to pages page 4-10, page 4-11, & page 4-12. EVERY 250 HOUR SERVICE 1. Lubricating - Apply adequate supply of grease to the following fittings: Dump body hinge pin - 2 points Rear suspension - 4 points Axle support pins - 8 points Hoist cylinder pin - 4 points Front suspension assembly - 8 points Steering cylinder pin - 4 points Steering linkage - 5 points Drive Shafts • Front - 2 points • Rear - 3 points 2. BATTERY - Check electrolyte level and add dis- tilled water if necessary to maintain proper level. 3.
ALTERNATOR BELT - Check condition of the 24V alternator belt for evidence of belt slippage, proper tension or damage. 4. AIR CONDITIONER COMPRESSOR BELT - Check for condition of belt and proper tension. 5. TRANSMISSION CASE BREATHERS - Remove breathers, disassemble breathers, remove filter element, clean in solvent. Allow to air dry, reassemble and install. COMMENTS CHECKED INITIALS EVERY 250 HOURS