Maintenance - Section 4 OM4010 05/07 Page 4-12 Lubrication and Service EVERY 2000 HOUR SERVICE Truck Serial Number ________________________ Site Unit Number ____________________________ Maintenance for every 250, 500, and 1000 hours should also be carried out at this time. Date: __________ Hour Meter _________________ Name of Service Person ______________________ 1. STEERING, HOIST OIL TANK Drain oil from tank and refill tank to specified level, capacity 162 l (43 gal.). Refer to Lube Key C. Refer to Hydraulic Tank Service , page 4-14. Remove and replace the two high pressure filter elements. Refer to High Pressure Hydraulic Fil- ters, page 4-16. 2.
REAR BRAKE COOLING OIL TANK Drain oil from tank and refill tank to specified level capacity 268 l (71 gal.). Refer to Lube Key E. To reduce rear brake squeal, use only SHELL DONAX - TD Oil or BP TRACTRAN UTH. If these oils are not available, use Lube Key C. Refer to Hydraulic Tank Service , page 4- 14. 3. FINAL DRIVE CASE Position machine so that casting line is horizon- tal and drain plug is at the bottom. Drain oil and reinstall plug, remove fill plug at cast line and fill to specified level. This operation is performed on the right and left hand final drives. Capacity is 64 l (17 gal.) each side. Refer to Lube Key B . 4.
DIFFERENTIAL CASE Drain oil from differential and refill to the speci- fied level: capacity 130 l (34 gal.). Refer to Lube Key B. 5. EMERGENCY RELAY VALVE Disassemble emergency relay valve, clean and inspect for damaged or worn parts. Replace all rubber parts also any that were found damaged, then reassemble. 6. ENGINE FRONT TRUNNION Apply grease. Refer to Lube Key D. 7. DUMP CONTROL LINKAGE - 3 points Apply grease. Refer to Lube Key D. COMMENTS CHECKED INITIALS