Komatsu — EVERY 5000 HOUR SERVICE

OM4010 05/07 Maintenance - Section 4 Lubrication and Service Page 4-13 EVERY 5000 HOUR SERVICE Maintenance for every 250, 500, and 1000 hours should also be carried out at this time. Truck Serial Number ________________________ Site Unit Number ____________________________ Date: __________ Hour Meter _________________ Name of Service Person ______________________ 1. ENGINE DRIVELINE ADAPTER Inspect driveline adapter splines, rubber damp- ers for cracks or separation on rubber surfaces, and bearings. Note any discrepancies and repair as required. Refer to Shop Manual, Section C for repair pro- cedures. 2.

FRONT AND REAR DRIVESHAFTS If the truck is equipped with driveshaft universal joints that DO NOT have grease fittings, inspect both front and rear driveshafts for binding, wear, vibration, or damage to the driveshaft assembly. If U-joint damage or roughness is noted, BOTH U-joints on a given shaft should be replaced. Refer to Shop Manual, Section F for replace- ment procedures. 3. FRONT SUSPENSIONS Drain Front suspension oil. Inspect upper flange internal bearing. Replace worn parts. Refill suspensions with clean oil and recharge with nitrogen. Refer to Shop Manual, Section H for instructions and WARNINGS when servicing suspensions. 4.

FRONT WHEEL BEARINGS Check front wheel bearing adjustment. Refer to Shop Manual, Section G, Front Wheel Hub Bearing Adjustment . COMMENTS CHECKED INITIALS