Maintenance - Section 4 OM4010 05/07 Page 4-16 Lubrication and Service HIGH PRESSURE HYDRAULIC FILTERS Filter Assembly Removal 1. Lower the dump body and turn off the engine. Clean dirt accumulation from the high pressure hydraulic filters and tube connections in front of the hydraulic tank. Any operating fluid, such as hydraulic oil or brake oil, escaping under pressure, can have suf- ficient force to enter a person's body by penetrat- ing the skin. Serious injury and possibly death may result if proper medical treatment by a phy- sician familiar with this injury is not received immediately. 2.
Turn the oil filler caps (3 and 8, Figure 4-3) slowly counter-clockwise to release internal tank pressure. 3. Place a receptacle under the filters to receive hydraulic oil which will drain from filters when disconnected. FIGURE 4-6. HIGH PRESSURE FILTERS & PIPING 1. Capscrew 2. Washer 3. O-Ring 4. Capscrew 5. Washer 6. U-Bolt 7. Filter Assembly 8. Capscrew 9. Washer 10.Split Flange 11.Bracket (on Hydraulic Tank) 12.Washer 13.Nut 4. Remove capscrews (1, 4, and 8, Figure 4-6), washers (2, 5, and 9), and split flanges (10) securing filters (7). Move hydraulic tubes away from filter housings. 5. Remove nuts (13) and washers (12) holding U- bolts (6) to bracket (11).
Remove filter assem- blies (7). Discard O-rings (3). Plug or cover all open hydraulic connections to prevent entry of contaminants and move filter assemblies to a clean service area. 4. Carefully align all components and connections to prevent any binding or kinking. Then begin tightening all capscrews and nuts sequentially to final required torque Filter Assembly Installation 1. Remove plugs and/or covers from connections. Install new O-rings (3, Figure 4-6) in all loca- tions. Install filter assemblies (7) to outlets and install capscrews (1 and 4), washers (2 and 5). Do not tighten capscrews to final torque at this time. .
Tighten all connections before starting engine and applying hydraulic pressure. 2. Move hydraulic tubes to filter housings inlets and reconnect with capscrews (8), washers (9), and split flanges (10). Do not tighten capscrews to final torque at this time. 5. Start the engine and check for leaks before releasing the truck for service. Check the hydraulic tank oil level to ensure that the oil level is visible in the center portion of the sight glass (4, Figure 4-3). 3. Install U-bolts (6) holding filter assemblies (7) to bracket (11). Install washers (12) and nuts (13). Do not tighten nuts to final torque at this time.