Komatsu — HYDRAULIC TANK SERVICE

OM4010 05/07 Maintenance - Section 4 Lubrication and Service Page 4-15 HYDRAULIC FILTERS Filter Replacement 1. Lower the dump body and turn off the engine. Any operating fluid, such as hydraulic oil or brake oil, escaping under pressure, can have suf- ficient force to enter a person's body by penetrat- ing the skin. Serious injury and possibly death may result if proper medical treatment by a phy- sician familiar with this injury is not received immediately. 2. Turn oil filler caps (3 and 8, Figure 4-3) slowly counterclockwise to release internal tank pres- sure. 3. Remove bolts (2) on filter covers (1). 4. Remove filter elements (2, Figure 4-4) from housing. 5.

Thoroughly clean filter housings, covers (4) and bypass valve (3) components. FIGURE 4-4. HYDRAULIC TANK FILTERS 1. Hydraulic Tank 2. Filter Element 3. Bypass Valve 4. Cover 6. Install new filter elements. Install bypass valves and covers. Tighten bolts (2, Figure 4-3) to required torque. 7. Check oil to ensure that the level is visible in the center portion of the sight glass. HYDRAULIC TANK BREATHER Cleaning 1. Turn off the engine and open hydraulic tank filler caps slowly to relieve any internal pres- sure. 2. Clean dirt accumulation from area of breather (9, Figure 4-3). 3. Remove the breather from the tank. 4. Remove snap ring (1, Figure 4-5), cover (2) and filter element (3). 5.

Clean breather element in solvent and allow to dry. Clean remaining parts in solvent and allow to dry thoroughly. Replace element if damaged or cannot be cleaned thoroughly. FIGURE 4-5. HYDRAULIC TANK BREATHER 6. Install element, cover, and snap ring. 1. Snap Ring 2. Cover 3. Element 7. Install breather element on hydraulic tank.