Komatsu — TRANSMISSION FILTER

Maintenance - Section 4 OM4010 05/07 Page 4-18 Lubrication and Service TRANSMISSION FILTER The transmission filter element should be replaced every 500 hours of operation or sooner. This mainte- nance interval may be reduced depending upon the operating conditions or if the warning light indicates a filter restriction. This filter assembly is equipped with a pressure switch to indicate a high differential pressure (restric- tion). The switch will close at 2.5 kg/cm 2 (35 psi) by- pass pressure. Actual bypass of the hydraulic filter does not occur until 3.5 kg/cm 2 (50 psi) differential pressure. Service 1. Remove drain plug (7, Figure 4-8) and drain the oil from the filter housing.

Tighten plug after all oil is drained. 2. Unscrew filter bowl (4) from head assembly (1). 3. Remove the element. Thoroughly clean and allow all parts to dry. 4. Coat new seal (9) with clean engine oil and install. 5. Install new element (5) and install filter bowl (4) into head assembly (1). 6. Start the engine and let it idle for five minutes. Stop engine and check for leaks. Check trans- mission for proper oil level and adjust if neces- sary. FIGURE 4-8. TRANSMISSION FILTER 1. Head Assembly 2. Core Kit 3. Bypass Valve 4. Filter Bowl 5. Filter Element 6. Pressure Switch 7. Drain Plug 8. O-Ring 9. Seal