OM4010 05/07 Maintenance - Section 4 Lubrication and Service Page 4-19 PERIODIC REPLACEMENT OF COMPONENT PARTS FOR SAFETY DEVICES To ensure safe operation the user must perform all periodic maintenance at the recommended intervals. Additionally, special care should be paid to the peri- odic replacement of parts which may affect safe operation. The following parts are recommended for repair or replacement every 4000 hours or every two years, whichever comes first: Fabrication of safety devices and other component parts have been designed to high standards. How- ever, all parts are subject to wear and gradual fatigue while in use.
Therefore, it is difficult to accurately determine the process of change in quality, wear, or fatigue. Judgments must be made whether or not some parts should be replaced even if they do not show any faulty symptom at the time. 1. Fuel Pump Screen Filter - Check and clean or replace screen filter. 2. Periodic Replacement Safety Parts Kit - Use the periodic replacement safety parts service kit when replacing the parts. 3. High pressure hoses in the steering circuit (to/ from pump, demand valve, steering valve, steering cylinder)* Any part found to have an abnormality should be repaired or replaced regardless of the time in service. 4.
High pressure hoses in the hoist circuit (to/from pump, demand valve, hoist valve, hoist cylin- der)* NOTE: This recommendation for the replacement of parts is to ensure safe operation. The warranty guarantee to be free from manufacturing defects does not apply to the replacement of functioning parts for precautionary reasons. 5. Outlet hose of retarder cooling oil pump* 6. Outlet hose of steering oil pump* 7. Outlet hose of transmission oil pump* 8. Steering valve hose* The following parts should be considered for repair or replacement every 2000 hours , or every one year, whichever comes first: 9.
Hose of fuel filter* *The replacement of these parts may be considered for Fire Prevention measures. 10. Fuel hose* 1. Brake valve parts 2. Parking brake valve parts 3. Relay valve parts 4. Air governor parts 5. Retarder control valve parts 6. Emergency relay valve parts Other areas of the truck also require inspection and may require periodic replacement of parts due to conditions. Rubber or plastic parts which are sub- jected to extreme heat or constant sunlight will deteri- orate more rapidly than parts in less severe service. 7. Emergency brake valve parts 8. Quick release parts 9. Parking brake chamber parts 10. Brake chamber parts (front and rear) Periodically check the following: 11.
Engine Valve Clearance - Refer to the engine manual for the proper inspection, procedures, and recommended tools. 1. Air inlet piping elbows close to turbochargers and exhaust manifolds 2. Air cleaner plastic bonnets 12. Brake Discs - Refer to “Brake Circuit Checkout and Adjustment,” this section, or the shop man- ual Section J, Brake System, Brake Circuit Checkout And Adjustment, for proper inspec- tion, procedures, and recommended tools. 3. Door seals 4. Windshield wiper blades 5. Windshield washer bottle 6. Plastic covers and caps 7. Water piping elbows and hoses 8. Body cushion pads 9. Plastic tubing for air lines