Komatsu — CHECKING FRONT BRAKE PAD WEAR

Maintenance - Section 4 OM4010 05/07 Page 4-20 Lubrication and Service BRAKE CIRCUIT CHECKOUT AND ADJUSTMENT CHECKING FRONT BRAKE PAD WEAR NOTE: This check is nominally specified for every 500 hours of truck operation. If truck is operated in a very abrasive environment (i.e. sandy conditions), perform this check every 250 hours of truck operation or more frequently, if conditions require. 1. Stop the machine on level ground and apply the parking brake. Then, place wheel chocks in front of, and behind the tires, to help prevent truck movement. 2. Remove any dirt/mud accumulation from all pads, calipers, and discs. 3.

Check disc pad (1, Figure 4-9) visually, and if the pad has reached the wear limit line (2) or if disc material thickness is less than 3 mm (0.12 in.), replace the pad. The pad wear may not be the same for both left and right wheels, so check the wear of all pads. If any pad is worn beyond the limits, as stated above, all pads must be replaced on both left and right sides. FIGURE 4-9. FRONT PAD WEAR 1. Brake Pad 2. Wear Limit Line Refer to the Shop Manual, Section J, Brake System , for specific disassembly, repair, and replacement procedures for the front brake assembly. Do not continue to use pads worn beyond limits. Worn pads may result in inadequate braking power.

TESTING BRAKE PRESSURE 1. Raise the air pressure to 8.3 kg/cm 2 (118 psi) pressure. 2. Remove the top air bleed plug (1, Figure 4-10) and install a 400 kg/cm 2 (5690 psi) pressure gauge. FIGURE 4-10. FRONT BRAKE PRESSURE 1. Air Bleed Plugs 2. Brake Line 3. Measure the hydraulic pressure when the brake pedal is depressed. Minimum pressure should be 187 kg/cm 2 (2660 psi). 4. Remove gauge and install plug. Refer to Brake Bleeding in this section and bleed the air from the calipers.