OM4010 05/07 Maintenance - Section 4 Lubrication and Service Page 4-21 CHECKING REAR BRAKE DISC WEAR Operational complaints can be expected when brake disc wear increases abruptly or the wear is uneven between the two sides. . Carry out inspection ONLY when the brake oil temperature is below 60°C (140°F). 1. Stop the truck on level ground, apply parking brake lever to the PARKING position, check that the other brakes are not applied, then turn off the engine. Place wheel chocks in front of and behind tires to help prevent truck movement. 2. Remove air bleed plug (1, Figure 4-11) located on the rear brake. Install disc wear measure- ment gauge as shown in Figure 4-12. FIGURE 4-11.
REAR BRAKE WEAR NOTE: Part number of wear gauge: 561-98-61120. 1. Air Bleed Plug 2. Brake Housing 3. Turn keyswitch to ON, and ensure that the air pressure gauge indicates in the GREEN range. If the air pressure is low, run the engine at 2000 RPMs until the air pressure gauge indicates in the GREEN range [8.3 kg/cm 2 (118 psi)]. Turn keyswitch to OFF to stop the engine. 4. Pull retarder control lever to full stroke. Push the wear gauge in until it contacts the piston, then check the position of the stamped mark on the rod. (See figure 4-12) NOTE:
When the retarder control lever is pulled, the wear rod will push out under hydraulic pressure; be sure to support the rod when carrying out this operation. If the stamped mark on the rod goes in beyond the end face of the case, the discs have reached their service wear limit. Refer to Shop Manual, Section J, Brake System, for specific disassembly, repair, and replacement procedures for the rear brake assembly. FIGURE 4-12. REAR BRAKE WEAR TOOL If the stamped mark on the rod does NOT go in beyond the end face of the case, but IS NEAR the service limit, carry out inspection more frequently. Also, carefully check the retarder capacity. 1. Handle 2. Rod 3. Stamped Line 4. Face of the Case 5.
After measuring the disc wear, remove wear gauge and install the air bleed plug. 6. Refer to Brake Bleeding , in this section and bleed air from the system