4. Check for oil leakage from the transmission case, axle, hydraulic tank, hoses, joints. Check that there is no oil leakage. If there is a problem, repair the leakage. OPERATION 5. Check for oil leakage from the brake line. Check that there is no oil leakage. If there is a problem, repair the leakage. 6. Check for damage to the lamps. Remark Before starting operations, clean all dirt from the surface of the lamps. If the lamps are used with mud stuck to the surface, the lamp may overheat and be damaged. If the lamp is cleaned when it is overheated, the sudden change in temperature may cause the lens to crack.
Turn the lamp off and wait for the temperature to go down before cleaning the lamp. 7. Check for loose air cleaner mounting bolts. Check for loose bolts. Tighten any loose bolts. 8. Inspect rims. Check the rims (wheels) and rings to confirm that there is no deformation, corrosion, or cracks. In particular, check the side rings, lock rings, and rim flanges thoroughly. 9. Check for damaged or worn tires, wheels, and wheel hub bolts. Check for loose mounting bolts. Check for cracks or peeling of the tires and for cracks or wear to the wheels (side rim, rim base, lock ring). If there is an abnormality, repair or replace the part. Tighten any loose wheel bolts.
If any valve caps are missing, install new caps. If worn or damaged tires are used, they may burst and cause serious injury or death. To ensure safety, do not use tires exhibiting the following characteristics. Wear: Tires with a tread groove of less than 15% of that of a new tire Tires with extreme uneven wear or with stepped-type wear Damage: Tires with damage which has reached the cords, or with cracks in the rubber Tires with cut or pulled cords Tires with peeled (separated) surface Tires with damaged bead Deteriorated, deformed, or abnormally damaged tires which do not seem usable. Leaking or improperly repaired tubeless tires WA500-3LK 2-43