Komatsu — Precautions Before Starting Work Operations

OPERATION 10. Check for loose battery terminals. Tighten any loose terminal. 11. Clean the cab window. Clean the cab window to ensure good visibility when operating the machine. 12. Check rear view mirror, underview mirror. Check that the mirrors are not damaged. Replace them if they are damaged. Clean the surface of the mirrors and adjust the angle so that the operator can see the area to the rear and under the machine from the operator's seat. When cleaning the mirrors, use a mop with a long handle. 13. Check for loose ROPS mounting bolts. If any loose bolts are found, tighten them to 927 ±103 N•m (683.7 ±76.0 lbf ft). If bolts are damaged, replace them with genuine Komatsu bolts. 14.

Check for damage and loose bolts on the handrail and steps. Repair any damage and tighten any loose bolts. 15. Check for damage to the seat belt and mounting clamps. Check that there are no loose bolts on the equipment mounting the seat belt to the machine. Tighten the bolts if necessary. Tightening torque:. . . . . . . . . . . . . . 24.5 ±4.9 N•m [18.1 ±3.6 lbf ft] If the belt is damaged or fluff is starting to form, or if there is any damage or deformation of the seat belt holders, replace the seat belt. Even if there appears to be no abnormality with the seat belt, replace it once every three years.

Remark The date of manufacture of the seat belt is marked on the belt at the place indicated by the arrow in the figure to the right. 16. Check for damage to gauges, lamps on the instrument panel, and loose bolts. Check for damage to the panel, gauges, and lamps. If there is a problem, replace the parts. Clean off any dirt on the surface. Tighten any loose bolts. 2-44 WA500-3LK