Komatsu — Loading Dump Truck

Approaching Dump Truck OPERATION Do not operate the steering suddenly when the bucket is raised. If the steering is operated when the bucket is raised, there is danger that the machine may tip over and cause serious personal injury. Remark Do not shift down with the accelerator pedal depressed (with the engine speed raised). If the transmission is shifted down when the engine speed is high, there will be an excessive load on the engine, torque converter, transmission, axles, final drive, and the whole power train. In addition, the tires will slip; this will cause wear of the tires.

Do not operate the steering immediately after switching between forward and reverse (when the machine is stationary). If the steering is operated when the machine is stationary, it will cause wear or cuts to the tires. If a transmission cutoff system is installed, turn the transmission cutoff switch to the OFF position and depress the brake, but do not raise the bucket. In this condition, the brake is operated. Heat is generated in the brake chamber; this heat will cause heat fatigue to parts inside the axle. 1. Let the accelerator pedal back to reduce the engine speed and then depress the parking brake pedal to stop the machine. 2. Shift gear from R2 to F2. 3.

Operate the steering to set the load at right angles to the dump truck and then drive forward. Remark Operate the steering in the following order: let accelerator pedal back switch between forward and reverse depress accelerator pedal to drive forward approach dump truck. If these operations are carried out at the same time, the engine acceleration will be poor resulting in poor fuel consumption. 4. Raise the bucket to adjust the bucket height so that when the bucket is tilted down, the cutting edge of the bucket does not hit the bottom face of the dump body or the dilution. Loading Dump Truck Do not load the dump truck suddenly from a high position.

If the dump truck is loaded in this manner, the dump truck will suffer impact load. There is danger that this may damage the body. Do not operate the dump or stop operations when the engine is running at high speed. There is danger of impact pressure being generated in the hydraulic equipment and causing damage to the hydraulic equipment. Do not shake the bucket violently to dump the load inside the bucket. The machine will sway and there is danger of damage to the machine. In addition, there is danger of impact pressure being generated in the hydraulic equipment resulting in damage to the hydraulic equipment. WA500-3LK 2-81