Komatsu — When Handling Blasted Rock

OPERATION If leveling operations are carried out with the machine traveling forward, do not make angle (a) between the cutting edge of the bucket and the ground surface facing down more than 8°. If leveling operations are carried out when driving forward with angle (a) between the cutting edge of the bucket and the ground surface facing down more than 8°, the bucket cylinder will be pushed by the pushing force of the machine. This will cause the cylinder to retract and the bucket will face down at a greater angle. There is danger of the work equipment breaking. Loading Bucket Do not load the bucket or scoop up the load with the load on the corner of the bucket or on one side of the bucket.

This will cause the machine to twist and will reduce the service life of the work equipment and the frame. When carrying out digging or scooping-up operations, thrust the center of the bucket into the load. Bucket Dump Operation When Digging Do not operate the bucket in the DUMP direction when digging. If the bucket control lever is operated to the DUMP position during digging, the machine will not be able to travel forward; the tires will slip; and an excessive load will be brought to bear on the work equipment. Carry out the scooping-up operations as follows. 1. When thrusting the bucket in, raise the lift arm slightly at the same time. Ample driving force will work on the front wheels. 2.

To fill the bucket, operate the bucket tilt and lift two to three times repeatedly when thrusting the bucket in. Operate the control lever slowly near the end of the bucket tilt. 3. When the bucket reaches the end of the tilt stroke, depress the brake pedal to stop the machine. When doing this, do not push the bottom of the bucket against the pile. If the bucket is pushed against the pile, the bucket, cylinders, and work equipment will be damaged. 2-86 WA500-3LK