4. When the scooping-up operation is completed, operate the bucket tilt and dump. Apply the brakes when traveling in reverse to stabilize the load inside the bucket and prevent spillage of the load. OPERATION Remark To reduce the generation of heat by the torque converter, keep the target time for the digging operation within 10 seconds from the start of thrusting in to the completion of scooping up. The fuel consumption increases during digging work. Fuel cost is saved by shortening the digging time. Front Wheels Going on Blasted Rock Do not carry out operations that make the front wheels ride up on blasted rock.
If the front wheels go on top of blasted rock, there is danger that the sharp parts of the blasted rock will cut the tires. In particular, avoid pushing the bucket in too far. When operating near natural rock after blasting (roots), do not let the front wheels ride up on the natural rock (roots). For scooping-up operations near natural rock (roots), do not use a wheel loader. Use a bulldozer or hydraulic excavator. Handling Loosened Boulders Do not use this machine to deal with loosened boulders. If the boulder is dropped by mistake when handling it, there is danger that it may fall on top of the operator's compartment and cause serious personal injury.
Do not use this machine to handle hanging rocks. There is danger that the rock will fall while moving it and hit the machine or operator's cab. If dropped boulders hit the work equipment cylinders, there is danger that the cylinder will bend and be unable to move. If the boulder is dropped on the operator's compartment, there is danger of serious personal injury. Pit Excavation Do not try to shave off natural rock (roots) remaining from blasting. Excessive force will be applied to the machine and there is danger that this may damage the work equipment or frame. For pit excavation operations, do not use a wheel loader. Use a bulldozer or hydraulic excavator. WA500-3LK 2-87