OPERATION During Cutting Face Operations Do not excavate cutting faces. If the cutting face is excavated, excessive force will be applied to the machine. There is danger that this may damage the bucket, work equipment, or frame. In particular, do not excavate with the bucket raised to a height above the travel posture. For excavation of cutting faces, use a hydraulic excavator. When Switching Between Forward and Reverse Do not switch the direction of travel of the machine between forward and reverse when traveling at high speed or when the accelerator pedal is depressed. When the machine is traveling at high speed or when the accelerator pedal is depressed, the engine speed is high.
If the direction of travel is switched between forward and reverse, an excessive load is applied to the engine, torque converter, transmission, and other parts of the power train. This will reduce the service life of the machine. When switching between forward and reverse, travel at low speed; reduce the engine speed; then stop the machine and switch the direction of travel. When Turning When Tires Are Stationary Do not operate the steering when the machine is stationary. If the steering is operated when the machine is stationary, it will cause wear or cuts in the tires. In addition, it will reduce the durability of the frame and the undercarriage. 2-88 WA500-3LK