Permissible Water Depth OPERATION When working in water or on swampy ground, do not let the water come above the bottom of the axle housing. After finishing the operation, wash and check the lubricating points. When Wheel Brake Does Not Work If the machine does not stop when you depress the brake pedal, use the parking brake to stop the machine. Remark If the parking brake has been used as an emergency brake, contact your Komatsu distributor to have the parking brake checked for any abnormality. When Driving Up or Down Slopes Lower the Center of Gravity When Turning When turning on slopes, lower the work equipment to lower the center of gravity before turning.
It is dangerous to turn the machine suddenly on slopes. Braking on Downhill Slope If the foot brake is used frequently when traveling downhill, the brake will overheat and may be damaged. To prevent this, shift down to a low range and use the braking force of the engine to reduce the speed. Normally, the most suitable speed range when traveling down a slope is the speed range needed when traveling up that slope. When braking, use the right brake pedal. If the correct speed range is not used, the torque converter oil may overheat. If this happens, shift down one speed to reduce the oil temperature.
If the indicator does not enter the green range even in 1st, stop the machine; place the directional selector lever at the N position; and run at the engine at a mid-range speed until the gauge enters the green range. If Engine Stops If the engine stops on a slope: Apply the parking brake immediately. Lower the work equipment to the ground. Stop the machine. Put the directional lever in the neutral position. Start the engine again. WA500-3LK 2-89