Komatsu — When Driving the Machine

OPERATION When Driving the Machine When the machine travels at high speed for a long distance, the tires become extremely hot. This causes early wear of the tires. Avoid traveling at high speed for a long distance. If the machine must be driven for a long distance, take the following precautions. Follow the regulations related to this machine and drive carefully. Before driving the machine, carry out the checks before starting; see “Check Before Starting Engine” on page 2-45. The most suitable tire pressure, travel speed, or tire type differ according to the condition of the travel surface. Contact your Komatsu distributor or tire dealer for information.

The following table is a guide to suitable tire inflation pressures and appropriate speeds when traveling on a paved surface with the standard tires. Check the tire pressure before starting, when the tire is cool. After traveling for one hour, stop for 30 minutes. Check the tires and other parts for damage. Check the oil and coolant levels. Always travel with the bucket empty. Never put calcium chloride or dry ballast in the tires when traveling. To prevent the radiator water temperature from rising suddenly, do not stop the engine suddenly. Run it at low idle for five minutes to cool it down gradually and then stop it.

2-90 WA500-3LK Item Tire Pressure Speed Front tire 0.34 MPa (3.5 kg/cm2) [49.3 psi] 19 km/h (11.8 mph) Rear tire 0.34 MPa (3.5 kg/cm2) [49.3 psi] 19 km/h (11.8 mph)