Komatsu — Adjusting Boom Kickout

Adjusting Work Equipment OPERATION Stop the machine on flat ground and put blocks in front and behind the wheels. Apply the parking brake. Secure the front and rear frames with the safety bar. Attach the warning tag to the work equipment control lever. Do not go under the work equipment when the arm is raised. The boom kickout makes it possible to set the bucket so that it automatically stops at the desired lifting height (lift arm higher than horizontal). The bucket positioner makes it possible to set the bucket so that it automatically stops at the desired digging angle. The setting can be adjusted to match the working conditions. Adjusting Boom Kickout 1.

Raise the bucket to the desired height; set the lift arm control lever at HOLD; and lock the lever in position. 2. Stop the engine and adjust in this manner: Loosen two bolts (1) and adjust plate (2) so that the bottom edge is in line with the center of the sensing surface of proximity switch (3). Tighten the bolts to hold the plate in position. 3. Loosen two nuts (4) to make a clearance of 3 to 5 mm (0.118 to 0.197 in) between plate (2) and the sensing surface of proximity switch (3). Tighten the nuts to hold in position. Tightening torque: . . . . . . . . . . . 17.2 ±2.5 N•m (12.69 ±1.84 lbf ft) 4. After adjusting, start the engine and operate the lift arm control lever.

Check that the lever is automatically returned to HOLD when the bucket reaches the desired height. WA500-3LK 2-91