Komatsu — Unloading Machine

OPERATION 9. Retract the antenna fully. 10. Adjust the mirrors so that they are within the width of the trailer. 11. Protect the exhaust stack from moisture, if necessary. Unloading Machine When unloading the machine, always use ramps or a platform. Be sure the loading area is flat and dry. 1. Unload on firm, level ground. Maintain a safe distance from the edge of the road. 2. Apply the brakes on the trailer and insert the blocks under the tires to ensure that the trailer does not move. 3. Fix the ramps in line with the centers of the trailer and the machine. Be sure that the two sides are at the same height. Make the angle of the ramps a maximum of 15°.

Set the distance between the ramps to match the center of the tires. If the ramps sag a lot, reinforce them with blocks, etc. 4. Remove the chains and wire ropes fastening the machine to the trailer. 5. Start the engine. Warm up the engine completely. 6. Set the safety lock lever to the FREE position. 7. Determine the direction of the ramps, then drive the machine slowly down the ramps. 2-104 WA500-3LK