Komatsu — LIFTING MACHINE

LIFTING MACHINE OPERATION Before lifting the machine, do the following steps to prevent the machine from moving unexpectedly. Stop the engine. Set the parking brake switch to the ON position. Set the lock lever to the LOCK position. The person using the crane to carry out lifting operations MUST be a qualified crane operator. Set the safety bar to the LOCK position to prevent the machine from articulating. Never lift the machine with a worker on it. Make sure the wire rope used for lifting is of ample strength for the weight of the machine. When lifting the machine, the wire rope must be fitted correctly or the machine may fall and cause serious injury or even death.

Raise the machine 100 to 200 mm (3.9 to 7.9 in) from the ground; check that the machine is horizontal; that there is no slack in the wire rope; and then continue to lift the machine. Never enter the area under or around a raised machine. There is danger that the machine may lose its balance. The lifting procedure applies to machines with standard specifications. The method of lifting may differ depending on the attachments and options installed. For details of the procedure for machines that do not conform to standard specifications, contact your Komatsu distributor. For details of the weight, see “SPECIFICATIONS” on page 4-2.

Remark Use protectors to prevent the wire rope from being cut on sharp corners and to prevent the wire rope from cutting into the machine bodywork. When using a spreader bar, select an ample width to prevent contact with the machine. When the machine is raised, check that there is no oil leakage from the hydraulic circuits. Consult your Komatsu distributor when carrying out the lifting operation. WA500-3LK 2-105