Komatsu — When Cold Weather Ends

Warming-Up Operation for Steering Hydraulic Circuit OPERATION If the oil temperature is low, when the steering wheel is turned and stopped there may be a time lag before the machine turns and stops. Set the safety bar to the LOCK position to ensure safety. Carry out the warming-up operation in an open area. Do not relieve the pressure in the hydraulic circuit continuously for more than five seconds. When the temperature is low, do not start the operation of the machine immediately after starting the engine. Warming Up Steering Hydraulic Circuit Slowly operate the steering wheel to the left and right to warm up the oil in the steering valve.

Repeat this operation for about 10 minutes to warm up the oil. Remark Turn the steering wheel a little and stop in that position. Confirm that the machine turns by an angle equivalent to the amount that the steering wheel is turned. Recommended Oil Select the oil according to the ambient temperature; see “RECOMMENDED FUEL, COOLANT, AND LUBRICANTS” on page 3-11. Precautions After Completion of Work Mud and water on the undercarriage can freeze overnight and make machine movement difficult the following morning. Observe the following precautions. Remove all mud and water from the machine body.

In particular, wipe the hydraulic cylinder rods clean to prevent damage to the seals caused if mud, dirt, and/or water on the rod surface gets inside the seal. Park the machine on hard, dry ground. If this is impossible, park the machine on wooden boards. The boards help protect the tires from freezing to the ground so the machine can be moved the next morning. Open the drain valve and drain any water collected in the fuel system to prevent it from freezing. Fill the fuel tank to capacity. This minimizes moisture condensation in the tank when the temperature drops. When Cold Weather Ends When the season changes and the weather becomes warmer, do the following procedure.

Replace all oil and fuel with fuel and oil of the specified viscosity. For details, see “RECOMMENDED FUEL, COOLANT, AND LUBRICANTS” on page 3-11. WA500-3LK 2-111