Komatsu — Releasing Parking Brake

OPERATION Releasing Parking Brake When releasing the parking brake, stop the machine on level ground and check that the surrounding area is safe. If it is necessary to release the brake on a slope in an emergency, block the tires before starting the operation. If the parking brake is released, there is no braking force. Ensure that the situation is safe when moving the machine. If the engine does not run for some reason, use the following methods to release the parking brake and tow the machine. Releasing Parking Brake by Using Emergency Parking Brake Cancel Switch If the pressure in the brake accumulator is high, do the following steps. 1. Turn the starting switch ON. 2.

Set the emergency parking brake switch to the CANCEL position. When doing this, check that the parking brake caution lamp goes out. When the switch is turned to the CANCEL position, the alarm buzzer sounds continuously. Remark Normally, keep this switch at the NORMAL position to actuate it. If the pressure in the brake accumulator is low, the parking brake caution lamp will not go out and the alarm buzzer will sound with a continuous beep. If this happens, release the brake. For details, see “Releasing Parking Brake Mechanically” on page 2-119. 2-118 WA500-3LK