When towing a machine, tow it at a low speed of less than 2 km/h (1.2 mph) and for a distance of a few meters to a place where repairs can be carried out. OPERATION The machine should be towed only in emergencies. If the machine must be moved long distances, use a transporter. Check that the tow rope or bar is of ample strength for the weight of the machine being towed. If the machine being towed must travel through mud or up hills, use a tow rope or bar of a strength of a least 1.5 times the weight of the machine being towed. If the machine is moved suddenly, the tow rope or bar will be subjected to excessive load and may break. Start the machine gradually and travel at a constant speed.
When towing a machine downhill, use a larger machine for towing to provide ample rimpull and braking power, or connect another machine to the rear of the machine being towed. This prevents the machine from losing control and turning over. Towing may be carried out under different conditions; it is impossible to determine beforehand the requirements for towing. Towing on flat horizontal roads requires the minimum rimpull; towing on slopes or on uneven road surfaces requires the maximum rimpull.
When Engine Can Be Used If the transmission and steering wheel can be operated and the engine is running, it is possible to tow the machine out of mud or to move it for a short distance to the edge of the road. The operator should sit in the cab of the machine being towed and operate the steering in the direction that the machine is towed. When Engine Cannot Be Used When towing a machine with the engine stopped, use the following procedure. 1. The transmission oil does not lubricate the system; remove the front and rear drive shafts. If necessary, block the tires to prevent the machine from moving. 2. The steering cannot be operated; remove the steering cylinder.
Even if the brakes are in good condition, the brakes can only be used a limited number of times. There is no change in the operating force for the brake pedal but the braking force is reduced each time the pedal is depressed. 3. Connect the towing equipment securely. When carrying out towing operations, use two machines of at least the same class as the machine being towed. Connect one machine to the front and one to the rear of the machine being towed; remove the blocks from the tires; and tow the machine. 4. The parking brake cannot be turned OFF. Release the parking brake; see “Releasing Parking Brake” on page 2-118. WA500-3LK 2-117