Komatsu — Towing the Machine

OPERATION Towing the Machine Serious injury or death could result if a disabled machine is towed incorrectly or ir there is any mistake in the selection or inspection of the wire rope. Always be sure to check carefully that the capacity of the wire rope used for towing is ample for the weight of the towed machine. Never use a wire rope which has cut strands (A), reduced diameter (B), or kinks (C). There is danger that the rope may break during the towing operation. Always wear leather gloves when handling wire rope. Never tow a machine on a slope. During the towing operation, never stand between the towing machine and the machine being towed. Move the machine gradually to a constant speed.

Do not to apply any sudden load on the wire rope because the towing wire may break. If the steering and the brakes on the disabled machine cannot be operated, do not let anybody ride on the disabled machine. If there is a failure in the engine or brake system, the brakes cannot be used. Be extremely careful when towing. Remark Towing is for moving the machine a short distance to a place where inspection and maintenance can be carried out. The machine must not be towed for long distances. For details of the permissible towing load for this machine, see “SPECIFICATIONS” on page 4-2. Do not tow any load greater than this.

For details about the procedure for towing a machine when it has broken down, contact your Komatsu distributor. This machine must not be towed except in emergencies. When towing the machine, take the following precautions. Before releasing the brakes, put blocks under the wheels to prevent the machine from moving. If the wheels are not blocked, the machine may move suddenly. If it is impossible to operate the steering and brakes of the machine being towed, do not let anyone ride on the machine. Keep the angle of the tow rope as small as possible. Keep the angle between the center lines of the two machines to within 30 degrees.

The towing machine should normally be of the same class as the machine being towed. Check that the towing machine has ample braking power, weight, and rimpull to allow it to control both machines on a slope or on the tow road. Use the specified towing pin for both the towing machine and the machine being towed. To protect the operator if the towing wire or towing bar breaks, install protective plates on both the towing machine and the machine being towed. 2-116 WA500-3LK