Komatsu — Outline of Electric System

Storing Oil and Fuel MAINTENANCE Keep oil or fuel indoors to prevent any water, dirt, or other impurities from getting into it. When keeping a drum for a long period, put the drum on its side so that the filler port of the drum is at the side. This prevents moisture from being sucked into the drum. If the drum must be stored outside, cover it with a waterproof sheet or take other measures to protect it. To prevent any change in quality during long-term storage, be sure to use the oil or fuel in the order of “first in - first out” (use the oldest oil or fuel first). Filters Filters are extremely important safety parts.

Filters prevent impurities in the fuel and air circuits from entering important equipment where they could cause problems. Replace all filters periodically. Details are provided in the SERVICE PROCEDURE section of this manual. When working in severe conditions, replace the filters at shorter intervals according to the oil and fuel (sulfur content) being used. Never try to clean the filters (cartridge type) and use them again. Always replace with new filters. When replacing oil filters, check if any metal particles are attached to the old filter. If you find any metal particles, contact your Komatsu distributor. Do not open packs of spare filters until just before they are to be used.

Always use Komatsu genuine filters. Outline of Electric System It is extremely dangerous if the electrical equipment becomes wet or the covering of the wiring is damaged. This situation will cause an electrical short circuit and may cause the machine to malfunction. Do not wash the inside of the operator’s cab with water. When washing the machine, be careful not to let water get into the electrical components. Service relating to the electric system: Checking fan belt tension Checking damage or wear to the fan belt Checking the battery fluid level Never install any electric components other than those specified by Komatsu.

External electromagnetic interference may cause malfunction of the control system controller. Before installing a radio receiver or other wireless equipment, contact your Komatsu distributor. When working at the seashore, carefully clean the electrical system to prevent corrosion. The optional power source must never be connected to the fuse, starting switch, or battery relay. WA500-3LK 3-9