MAINTENANCE STANDARD TIGHTENING TORQUES FOR BOLTS AND NUTS If nuts, bolts, or other parts are not tightened to the specified torque, it will cause looseness or damage to the tightened parts. This will cause failure of the machine or problems with operation. Always pay careful attention when tightening parts Unless otherwise specified, tighten the metric nuts and bolts to the torque shown in the following table. If it is necessary to replace any nut or bolt, always use a Komatsu genuine part of the same size as the part that was replaced.
Tightening Torque Table 3-14 WA500-3LK Thread Diameter of Bolt (a) Width across Flats (b) Tightening Torque Target Value Service Limit mm mm N•m kgm lbf ft N•m kgm lbf ft 6 10 13.2 1.3 9.7 11.8 – 14.7 1.2 – 1.5 8.7 – 10.8 8 13 31 3.2 22.9 27 – 34 2.8 – 3.5 19.9 – 25.1 10 17 66 6.7 48.7 59 – 74 6.0 – 7.5 43.5 – 54.6 12 19 113 11.5 83.3 98 – 123 10.0 – 12.5 72.3 – 90.7 14 22 177 18.0 130.5 157 – 196 16.0 – 20.0 115.8 – 144.6 16 24 279 28.5 205.8 245 – 309 25.0 – 31.5 180.7 – 227.9 18 27 382 39.0 281.7 343 – 425 35.0 – 43.3 253.0 – 313.5 20 30 549 56.0 404.9 490 – 608 50.0 – 62.0 361.4 – 448.4 22 32 745 76.0 549.5 662 – 829 67.5 – 84.5 488.3 – 611.4 24 36 927 94.5 683.7 824 – 1030 84.0 – 105.0 607.8 – 759.7 27 41 1320 134.6 973.6 1180 – 1470 120.3 – 149.9 870.3 – 1084.2 30 46 1720 175.4 1268.6 1520 – 1910 155.0 – 194.8 1121.1 – 1408.7 33 50 2210 225.4 1630.0 1960 – 2450 199.9 – 249.8 1445.6 – 1807.0 36 55 2750 280.4 2028.3 2450 – 3040 249.8 – 310.0 1807.0 – 2242.2 39 60 3280 334.5 2419.2 2890 – 3630 294.7 – 370.2 2131.6 – 2677.3